So, like I needed any more projects or any more computers, but I bought a receipt printer and two POS terminals. Both are Celeron J1900 I think at 3Ghz, 128G hard drive and I’m not sure of the memory. All that cost me a whopping $45, so how could I resist? Right now we’ve got the POSBANK unit working, you can see me updating...
Hey all. I’m using arch linux and after trying to fix my fonts to get nicer icons etc. in the terminal i’ve made a mess 😔 Any ideas on how to uninstall all the fonts and start fresh?
I just installed Fedora and I’m trying to figure out how to make it display Japanese fonts, by default it displays kanji as Chinese characters, I installed some fonts but still no change, how do I change this?
I was running KDE Neon on ThinkBook 15 G2 and had deep sleep working after adding mem_sleep_default=deep to GRUB_CMDLINE. It worked for a while until it didn’t. I didn’t do anything other than running regulat updates. Since couple weeks back, when going to sleep, it shows BIOS Recovery progress bar or something and restarts....
I want to run a command and see all of its output on the left hand side, while simultaneously searching/grepping for particular lines on the right hand side. In other words, I want a temporary vertically split screen in my CLI, ideally with scrollback on each side of the split, but where I expect the left hand side to be...
Today, I made switch to fedora silverblue and then rebased to ublue image because it has flatpak included in the image. I am also thinking about making my own image based on silverblue. there is a video made by bigpod a youtuber about how to make your own custom ublue image and I learned a lot from that video. I am using toolbox...
EDIT: I enabled CONFIG_MSDOS_PARTITION and that caused it to work. It had nothing to do with the device itself but the partition type on the sd card....
So I got a stream deck recently and installed boatswain. It works fine except it cannot access any apps which actually show in the application menu. It is only available as a flatpak so that could be it
Yesterday night I had a problem with a usb port and the touch pad not working, I restarted the system a few times and switched back and forth with windows (which is installed on a different drive), they didn't work even there.After a few restarts the usbport and the touch pad came back to life, but the wifi stopped working. When...
I have a Python-package that calls Inkscape as part of a conversion process. I have it installed, but through Flatpak. This means that calling inkscape does not work in the terminal, but rather flatpak run org.inkscape.Inkscape. I need the package to be able to call it as inkscape....
Edit: copying the font to /usr/local/share/fonts/ fixed it. (I downloaded Debian Xfce a while ago because of how much I dislike Snap, so I’ll soon replace Xubuntu with it.)...