I’m getting a little bit frustrated with my AliExpress 2.54mm dupont ribbon cables. The female housings get loose after just a few cycles, and the connections start falling apart easily....
PS For future reference, does this sort of exposed PCB trace (pad?) used for electrical connection take solder well?
I can’t tell if you have gold plate or just raw copper (probably gold. But in either case, yes, it is solderable. You can think a little bit about how they manufacture the boards. First the print on the green solder resist, then they dunk it into an electroplating bath for a gold finish, or a dunk it in solder for HASL. It would be a lot of trouble to go through (=$$$) to individually mask off that part of the board for some special process.
I'm planning to add a momentary switch to a single loop DC circuit. Will this cause any amount of resistance in the circuit? I'm a complete noobie when it comes to electronics, any resource links or clarification is appreciated. I know the type of material/width of wire and a pot will cause resistance but will any component put...
Unless you've managed to get a switch made out of superconducting material and you're working inside a liquid helium bath, everything has resistance :)
You'll have a bad time trying to measure such low resistances, so usually you can look at the datasheet for the switch you're using or for a similar switch if you need a ballpark number. You'll see an on-resistance, and a max current (since there will be arcing when you open the switch).
If you do want to measure the low resistance, you'll need dedicated meter with a kelvin connection.
deleted_by_author
Where do I get good-quality dupont jumper wires?
I’m getting a little bit frustrated with my AliExpress 2.54mm dupont ribbon cables. The female housings get loose after just a few cycles, and the connections start falling apart easily....
Is this one-piece battery-to-PCB "clip" standard (for easy replacement) or a custom piece? +PCB pad ? (discuss.tchncs.de)
Hello,...
What creates resistance in a circuit?
I'm planning to add a momentary switch to a single loop DC circuit. Will this cause any amount of resistance in the circuit? I'm a complete noobie when it comes to electronics, any resource links or clarification is appreciated. I know the type of material/width of wire and a pot will cause resistance but will any component put...