It’s reverse: you get a board that has a floppy interface on one side and a USB socket on the other. You plug in a USB drive and the board uses a file on the drive as the floppy disk, pretending to be a floppy Drive connected to the interface. It’s a little less convenient because you have to deal with disk images but it works without moving parts.
Does anyone recognise these power supplies? They’re cheap AliExpress led drivers and I want to change its output voltage to around 22V from 12V. I’ve read that the way to do this is to adjust the REF voltage on the IC that controls it. It’s a KA3845 but I don’t understand where that reference voltage is regulated. One...
It’s probably not a good idea for actual use, but if you’d like to experiment: looks like the 3-pin devices U4 and U5 on the upper right provide feedback through the optocouplers next to the class Y cap north of the transformer. I bet those are LM431 voltage references (or similar). The passives around them provide filtering, but two of the resistors should form a resistor divider for the Ref pin (lower right pin if the single pin is on top). That divider sets the voltage.
abandonware empires (mander.xyz)
Adjusting SMPS output voltage (discuss.tchncs.de)
Does anyone recognise these power supplies? They’re cheap AliExpress led drivers and I want to change its output voltage to around 22V from 12V. I’ve read that the way to do this is to adjust the REF voltage on the IC that controls it. It’s a KA3845 but I don’t understand where that reference voltage is regulated. One...