I do that to my dead drives, but I’ve only had one fail that wasn’t an SSD. Moreso because the washers that separate the platters have a very satisfying ring to them that makes me keep them as a fidget toy.
I use the magnets to hold screws, it works great for that.
Unfortunately, SSDs have less interesting parts, so I just take them apart to destroy the chips after failure
That’s rad, and you did an amazing job keeping them whole. Recently I have been wrapping them in cloth, then the kids form clay around them for various fridge and office magnets.
That’s a good idea. Yeah, the trick I discovered in getting them off the mounting bracket without the chrome plating peeling is to grab each end of the bracket with vice grips and/or pliers (after you unscrew it from the drive) and just bend it down and away from the magnet. They usually come off in one piece that way, too.
I’ve done some of that, recently I have an old putty knife and I will put it right against the crack and just hammer it which will unstick it enough that I can pull it off. Newer drives definitely have weaker magnets than some of my much older ones.
Cool, I’ll try this next time. So far the least damaging way I’ve tried is putting the thing in hot water. The magnet and the base expand by different amounts and it is relatively easy to pry the magnet off. But the thing cools down quickly so it takes a few tries.
I was doing some blacksmithing in high school, mostly knifes.
When reaching 800°C steel is not magnetic anymore, it’s also a good temperature to start forging the steel. So I needed a atrong magnet to know when the steel was hot enough, I used what I have available: a hard drive magnet.
It felt quite “mad-maxy” to disassemble a broken hard drive to use it as a tool to forge knifes
That is a self-made soldering kit box I made when I was in college and had to haul it around a lot. I have actually been meeting to replace it with something more permanent now that I’m a grown up with my own house. I have an air flow soldering rig which doesn’t really have a home, and I could have a much better use of space. I have my brocade ICX6610-24 next to that which I’ve been programming for way too long, and a whole bunch of 3D printer parts on top of that.
That kit box would actually be perfect for my needs as this is a hobby I only visit occasionally or when needed. It would be great to have something I can easily store.
There’s always exactly one screw that won’t let go and I end up stripping it beyond hope, so I rarely get the platters out. I only want (need!) the magnets anyway!
Add comment