Is this a fuse? If so, what kind? if not, what is it? (beehaw.org)
I’m learning about electronic components. I believe this is the part which has broken and made this heating pad unsafe to use. Well, unusable, not just unsafe lol.
![](https://kbin.spritesserver.nl/media/cache/resolve/entry_thumb/ae/ab/aeab60b9adae6d548e274006b1c4292057228acf9916ef93e6926178994b7d4a.webp)
This magazine is from a federated server and may be incomplete. Browse more on the original instance.
I’m learning about electronic components. I believe this is the part which has broken and made this heating pad unsafe to use. Well, unusable, not just unsafe lol.
I had an old USB Oscilloscope (StingRay), it's 20+ years old now....
The purpose of this PCB is to be small, have ok RF performance, and use USB as main power-source and interface. (Off course it has UART if USB is not available) this is just a somewhat challenge I set myself to design a esp32 PCB with the IC without a already made module....
I have to fix a slightly very stupid mistake that I’ve made....
Hi!...
My project is a “breathing” white 12v LED strip controlled by an esp32 on a dev board, and switched with an IFLZ44N mosfet....
The lower part of my screen is updated one frame earlier than the upper part. I was able to isolate the error to the HDMI output of my laptop. The screen or cable is not broken, as I don’t get these errors with other connected devices. I am assuming it is some hardware defect. Does anyone know what it could be and how I could...
Solution: @DJPhil has made some really insightful comments below, which are really useful. If you just want the cap you can set the parametric searches for 660uF, or in September 2023 I’ve found that digikey stock(s/ed) chemi-con EKHJ451VSN661MA59M....
Hi,...
This photo shows the power conversion side of two versions of the same board. Input is up to 60V DC, board converts to 5V and then down to 3.3V....
A comprehensive mapping of old subreddits to new communities.
I'm currently looking into various DC DC converters and was confused that the Meanwell DDR-60 series only shows a typical rating but says nothing about the efficiency at idle. From AC/DC converters I'm used to have a curve that starts at idle and maybe 70% and goes to 100% load, having the peak at ninetee something....
I got it with https://sabrent.com/collections/hard-drive-accessories/products/ec-ch2b. But since I bought it in EU, it has that charger. Is there no alternative other than buying a whole new charger?
i can’t find ANYWHERE this ic chip, not even in chinese online stores. code is FMM862, laptop model is a Gateway GWTN141-10. it can also be another one that works. thanks in advance....
I’ve got an old oscilloscope and a function generator that I’m trying to use to play around and get more familiar with this kinda stuff. I’m mostly new to electronics (especially analog ones) and I’m having a hard time getting them setup properly....
Solution...