Haha your second paragraph sums it up perfectly. A few folks did share their settings, but they were for completely different printers/hardware haha. Most of the online guides I’ve found are written under the assumption that you’re already a master at the hobby, and it’s strangely spread out in random little nooks of the internet - there’s not really a ton of centralized discussion forums. Maybe the hobby is way smaller than I thought, or maybe I’m just in way over my head, but I fix tech problems for a living - did not expect this to be as much of a challenge. Never buy a 3D printer if you value your sanity and living stress-free. Sorry, I just needed to rant for a minute haha.