Solution: @DJPhil has made some really insightful comments below, which are really useful. If you just want the cap you can set the parametric searches for 660uF, or in September 2023 I’ve found that digikey stock(s/ed) chemi-con EKHJ451VSN661MA59M....
I’m learning about electronic components. I believe this is the part which has broken and made this heating pad unsafe to use. Well, unusable, not just unsafe lol.
I am wondering why there is no open framework for laser printing.
There are a few parts that would have to be made out of sheet metal. The sides could be stamped for the same pattern. You then need a back and a cross section. One could theoretically make them from ABS, but ABS gets brittle with heat and the sides will shatter.
One side of the printer is dedicated to running an ARM SOC. I’m not sure if the Arduino is up to the task, but it will need to control 3 motors, initiate a heating sequence, start a rasterizing laser, interpret a print job, communicate over network and USB, and monitor a bunch of sensors.
The hardest parts will be obtaining print cartridges, rollers, and fusers. Designing a standard to run off a certain vendor’s hardware will be a pile of issues, and nobody will just start manufacturing hardware for a handful of hobbyist printers.
Everything else is 3d printing, springs, and screws.
Yeah, that is one of the big problems I was considering. Even monochrome at 300 DPI would be a problem. The imaging array and drum would need to be manufactured separately and installed as whole unit.
SOLVED. Identification of angled snapin terminals on AC inverter filter cap (sh.itjust.works)
Solution: @DJPhil has made some really insightful comments below, which are really useful. If you just want the cap you can set the parametric searches for 660uF, or in September 2023 I’ve found that digikey stock(s/ed) chemi-con EKHJ451VSN661MA59M....
Is this a fuse? If so, what kind? if not, what is it? (beehaw.org)
I’m learning about electronic components. I believe this is the part which has broken and made this heating pad unsafe to use. Well, unusable, not just unsafe lol.
What do you do when you're hungover?
Had a bit too much last night and now I’m on my usual routine of water, ibuprofen, and waiting. Was curious if anyone has a better go to?
Completely untrue nowadays... (sh.itjust.works)
They work better in Linux than Windows, not to mention backwards compatibility....