The case is basically fully metal, just a bit of plastic inside for mounting the PCB to and a few other bits of plastic outside. Plus there is a temperature fuse in the case also.
From the resistor size (11.5 x 4.5mm) I think it would have been a 2W resistor when comparing to sizes on Digikey. I made a 500 Ohm 2W resistor from 8 1/4W 1K resistors then put a larger resistor in parallel to that to bring it down, measured it to 489 Ohms.
I’m going to run it a few times then open it up again to see if there is any new damage to the board before returning it.
Help finding value of burnt resistor. (lemmy.nz)
Mates bread maker stopped working so I had a look inside and saw this burned resistor....