Barrel of the via? I’m unfamiliar with that terminology – what is that? I did a continuity check from the very bottom to the very top and everything tested good. When the audio is out, twisting the header a bit would usually bring it back so I assume(d) it was just a poor connection somewhere despite the continuity check.
EDIT: Okay, some quick Googling got me understanding this better. As I mentioned, continuity is good, but I still suspect it’s something in this area. I suppose I could remove the connectors and install solder connectors, instead of press fit?
How to remove press fit connectors (discuss.tchncs.de)
I’m trying to repair an arcade PCB with intermittent audio. The board on top is the audio board, the bottom board is the everything else....